Teledyne HPAC-2005, Operation Manual

Page: 35 / 156

3 RU SSPA Chassis Operations Manual 205356 REV T 35
○ LowRF – Low RF level fault;
○ AuxFlt – Auxiliary fault;
○ BUCFlt – Block Up converter fault;
○ PSFlt- Power Supply fault;
○ ColdSt – Unit cold start power up detected;
○ N+1Flt – N+1 System Fault;
○ TmpFlt – High temperature fault;
○ RegFlt – Voltage Regulator fault;
○ CurFlt – Low DC Current fault;
○ HiVSWR – High reflected RF level fault;
○ Other – Unknown fault condition;
○ None – No information about present or past fault conditions (Clear
Fault function was implemented by user);
2.2.1.11 IP Info Page 1
This page is available through the Comm. Setup menu, and shows SSPA settings re-
lated to the IP interface.
•
IP Address
– IP address of the SSPA. Consult your network administra-
tor to set this address according to your LAN configuration.
•
MAC
– Medium Access Control address of the SSPA Ethernet controller.
This address is factory preset.
•
Subnet
– IP subnet mask of the SSPA. Consult your network administra-
tor to set this address.
•
IPPort
– IP port value for the SSPA. This address is valid only when IP-
Net protocol is selected. The port value should not be selected outside
the existing services range to avoid access conflict on the M&C PC end.
2.2.1.12 IP Info Page 2
This page shows SSPA settings related to the IP interface.
•
Gateway
– IP Gateway address. This address is used only if access to
the SSPA is provided from an outside LAN. If no such access is required,
the address must be set to 0.0.0.0
•
LockIP
– This address is used to increase the security measure for the
IPNet protocol. The SSPA will answer a request which comes only from a
specified IP address. Set this address value to 255.255.255.255 to disa-
ble this feature. See
Section 2.2.2.5.1
.