6712 Sampler
2-2
a. Ice the tub, if desired.
b. Install the strainer or end of the suction
line in the flow stream and route the
suction line to the sampler.
c. Install a module, if desired. Refer to the
module manual for instructions for
installing the module.
d. Place the sampler in position.
e. Connect any necessary external
instruments to the sampler.
3. Program the sampler.
Programming guidelines are in Section 1 of
the pocket guide and in more detail in the
6712 manual. Guidelines for programming
the module are in each module manual.
4. Run the sampling program.
5. Service the sampler.
a. Recover the sampler.
b. Collect the sample bottles.
c. Replace the battery if required.
d. Collect the sampling data.
e. Replace the sample bottles.
f. Run the sampling program.
2.2 Installing Distributor Arm
All 6712 Samplers use the same adjustable
distributor arm. The two-piece arm is marked
with positions A, B, C, and D. Table
shows
the arm positions and the discharge tube
Summary of Contents for 6712
Page 2: ......