User Manual
3
Operating Environment
The accessory is intended for indoor use and should be operated in a clean, dry
environment. Before using this product, ensure that its operating environment is
maintained within these parameters:
Temperature: 5° to 40° C
Humidity: Maximum relative humidity 90 % for temperatures up to 31° C
decreasing linearly to 50 % relative humidity at 40° C
Altitude: Up to 10,000 ft (3,048 m)
Introduction
The ZD series of differential probes (ZD500, ZD1000 and ZD1500) are high
bandwidth, high impedance, active differential probes. The probes feature low
noise, very high input impedance and high common mode rejection, and are
ideally suited for signal integrity measurements in high-speed digital systems.
With low input capacitance and high input resistance, circuit loading is
minimized.
The probes can be used with a variety of Teledyne LeCroy oscilloscopes
running MAUI firmware version 6.4.1.x or later. See the oscilloscope product
page at teledynelecroy.com/oscilloscopes for probe compatibility.
With the ProBus interface, the probe becomes an integral part of the
oscilloscope, able to be controlled from the oscilloscope’s front panel. The
oscilloscope provides power to the probe, so there is no need for a separate
power supply or batteries.
Key Features
Key Benefits
Features
1 MOhm input resistance
Low input capacitance
Wide dynamic range
ProBus interface
Small, low mass probe head is designed
for ease of use and high performance.
Probe tip socket fits easily onto 0.025
inch square pins for direct access to test
points. Several available adaptors
connect directly to the probe socket.
Complete accessory kit.