User Manual
3
Safety
To avoid personal injury or damage to the USB2-GPIB or any equipment
connected to it, review and comply with the following safety precautions.
Use only as intended.
Using the adapter or connected equipment in a manner
not specified by the manufacturer(s) may impair the protection mechanisms.
Connect and disconnect properly.
Do not disconnect the USB2-GPIB during
data transfer. The green LED of the USB2-GPIB stays lit while the
communication is in progress. Disconnecting equipment during this time may
result in data corruption or damaged equipment.
Do not use in wet/damp or explosive atmospheres.
For indoor use only.
The USB2-GPIB is intended for indoor use and should be
operated in a clean, dry, environment.
Do not operate with suspected failures.
Do not use USB2-GPIB if any part is
damaged. All maintenance should be referred to qualified service personnel.
Keep product surfaces clean and dry.
Connecting the Adapter
Insert the USB connector into the USB port of the oscilloscope, then attach the
IEEE-488/GPIB connector to GPIB port on the PC.
During the first use of the adaptor, Windows will install the device driver. You
may need to restart the oscilloscope for the adaptor to be functional.
Figure 1: Connecting USB2-GPIB.
Summary of Contents for USB2-GPIB
Page 1: ...User Manual USB2 GPIB Adapter...
Page 11: ...User Manual 9...
Page 12: ...933641 00 Rev A May 2021...
