10
One end of the sample transfer tubing is preconnected to the sample probe.
The transfer tubing should be long enough so that it there will be no strain on the tubing
connectors even when the sample probe is at the position farthest from the analytical
instrument.
1
Determine the length of the sample transfer tubing you need, and cut it to size.
2
Connect the free end of the sample transfer tubing to the inlet of the analytical instrument’s
peristaltic pump.
Connecting the Autosampler to the Power
Supply
The autosampler is powered by the supplied external desktop "brick" power supply. Ensure
that you position the autosampler so that the location where the power supply cord plugs
into it is easily accessible (is not blocked) and it can be quickly disconnected if needed. In
case of hazard, the system should be disconnected from the power source.
1
Turn the power switch on the autosampler OFF.
2
Check the plug on the power cord to verify that it is of the correct type for your country.
3
Plug the power cord into a power outlet.
4
Plug the power cord into the power supply.
F
IGURE
15
Power Supply
5
Plug the power supply into the 24 V connector on the autosampler.
6
Turn the power switch on the autosampler ON.
It is important to use the appropriate power cord for your country.
Power Cord to
Grounded AC Power
Outlet
To POWER
Connector on
Autosampler
