5
CONVERTING FROM DESK TO WALL MOUNT
The Opal 1010S can be changed for wall mounting applications. The conver-
sion is easiest when the handset and line cords are not connected.
1. Located on the top of the telephone above the speaker grill is the wall/
desk mount clip. Remove this clip by firmly pushing upward (towards the
hookswitch).
2. Flip the clip over (top to bottom) so that the protruding edge is towards
the top of the phone. This edge will hold the handset.
3. Turn the Opal 1010S over so the bottom is up facing you. Place the Opal
on a nonabrasive surface to prevent scratching.
4. Locate and remove the mounting bracket, firmly push back and pull up to
remove two of the four retaining tabs.
5. Rotate the mounting bracket 180 degrees clockwise so that the mounting
eyelet on the bracket is facing in the same direction as the other mounting
eyelet located on the bottom of the telephone.
6. Insert the top two retaining tabs of the mounting brackets into the mount-
ing bracket slots (located near the middle of the telephone). Then firmly push
down to insert the retaining tabs on the opposite side of the mounting
bracket.
7. Connect a short modular line cord into the jack on the back of the phone
(labeled LINE). Route the line cord through the line cord channel. Connect
the other end of line cord to the phone jack on the wall mounting plate.
8. Turn the telephone over, and slide the Opal 1010S down onto the mount-
ing posts in downward direction. Both eyelets should line up with the
mounting posts.
9. Complete the wall mounting by installing the handset and handset cord.
