PAUSE KEY
The Pause key, when programmed behind an autodial key can be used to
provide a timed pause between dialed digits within an autodial key. The
timing of the pause is programmable with the factory default set to zero (0)
seconds. To change the pause timing;
1. Lift the handset.
2. Press the STORE key (see diagram on page 6 for key location).
3. Press the PAUSE key (see diagram on page 6 for key location).
4. Select 1 - 9 on the DTMF pad. The number selected will be the new pause
timing in seconds (ie: “3” = 3 seconds).
5. Press the STORE key.
AUTO DIAL KEYS
The Opal 1010S has ten (10) programmable AUTO DIAL keys. These keys
can be programmed to automatically dial telephone numbers, or activate
telephone system features.
PROGRAMMING AUTO DIAL KEYS:
The telephone must be connected to a telephone line.
1. Remove the plastic overlay.
2. Lift the handset from the cradle or press the SPEAKERPHONE key.
3. Press the recessed STORE key and release it. (Please see diagram on page
6 for key location).
4. Enter the telephone number including PAUSE* as required. The sequence
can be up to 15 digits.
5. Press the AUTO DIAL key where the number is to be stored.
6. Place the handset back in the cradle or press the SPEAKERPHONE key to
disconnect.
4
