I SERIES ANALOG USER GUIDE
www.teledex.com
15
I SERIES AC SERIES PHONES (ANALOG CORDLESS)
CHARGING THE BATTERY
The rechargeable Ni-MH battery must be fully
charged before using the phone for the first
time.
It is recommended that the battery be charged for
approximately 10 to 12 hours without interruption
before use. To charge the battery, place the
handset, keypad down, in the base unit. Ensure
that the CHARGE LED on the base lights.
IF THE LED DOES NOT LIGHT
1. Ensure that the AC adapter is plugged in.
2. Ensure that the AC adapter is plugged into
an unswitched electrical outlet.
3. Ensure that the handset charging contacts
at the bottom of the handset are making
good contact with the base unit’s charging
contacts.
CLEANING THE BATTERY CONTACTS
To maintain a good charge, it is important to
clean all charging contacts on the handset and
base unit. Use a pencil eraser or other contact
cleaner. Do not use any liquids or solvents.
BATTERY SAFETY INSTRUCTIONS
1. Use only Teledex-approved battery
replacements.
2. Make sure the battery is properly disposed
of.
3. Do not dispose of battery in fire, as it may
explode.
4. Charge the battery only while in the
handset, and only by using the base unit
to charge. Do not attempt to remove
the battery and charge it in a separate
charging unit.
5. Do not short-circuit the battery, as this
may cause it to explode or catch fire.
CONVERTING FROM DESK TO WALL
MOUNT
The AC Series can be adapted for wall mounting
applications. The conversion is easiest to make
when the handset and cords are not connected.
1. Located on the handset cradle, above
the speaker grill, is the wall/desk mount
clip. Remove this clip by firmly pushing it
upward towards the top of the phone.
2. Flip the clip over (top to bottom) so that
the protruding edge is towards the top of
the phone and replace it in its slot.This
edge will hold the handset when the phone
is mounted on the wall.
3. Turn the telephone over so the bottom is
up, facing you. Place it on a non-abrasive
surface to prevent scratching.
4. Locate and remove the mounting bracket.
Firmly push back and pull up to remove
two of the four retaining tabs.
5. Rotate the mounting bracket 180 degrees
clockwise, so that the mounting eyelet on
the bracket is facing in the same direction
as the other mounting eyelet located on
the bottom of the telephone.
6. Insert the top two retaining tabs of the
mounting brackets into the mounting
bracket slots (located near the middle of
the telephone). Then firmly push down to
insert the retaining tabs on the opposite
side of the mounting bracket.
7. Connect a 15-foot RJ-45 cord into the LINE
jack on the back of the phone.
8. Turn the telephone over, and slide the
telephone down onto the mounting posts
of the wall bracket. Ensure that both
eyelets line up with the mounting posts.
The Ringer Equivalence Number (REN) of this
device is 0.7B.
