14
www.teledex.com
I SERIES ANALOG USER GUIDE
I SERIES AC SERIES PHONES (ANALOG CORDLESS)
Unpacking Your Telephone
This package should contain the following:
• Cordless handset
• AC adapter
• Base unit
• User guide
• Ni-MH battery
• Clear plastic overlay
• Rubber battery screw cover
• Phillips screw
• 15-foot, 8-wire cable (with RJ-45 connector)
• 10-foot, 4-wire line cord (with RJ-11 connector)
Installation
CAUTION INFORMATION
• Never install telephone or network wiring
during a lightning storm.
• Never install telephone or Ethernet jacks in
wet locations unless the jack is specifically
designed for wet locations.
• Never touch uninstalled telephone wires or
terminals unless the telephone line has been
disconnected at the network interface.
• Use caution when installing or modifying
telephone and network lines.
PREPARING TO USE THE AC SERIES
1. Prepare to install the battery into the
cordless handset by removing the battery
cover and sliding it off. If cover is secured
with a screw, remove the screw first.
2. Insert the battery connector into the
handset’s connector. The connector is
“keyed” so it only goes in one way. Do not
force the connection.
Note:
The handset may “beep” when the battery
is connected. This is not an indication that the
telephone is ready to use. To obtain optimal
performance of the telephone, be sure to charge
the battery for 10 to 12 hours.
3. Replace the battery compartment cover
and the retaining screw.
4. Insert the provided rubber screw cover.
5. Turn the telephone base so the back panel
is facing you. Insert either end of the
RJ-45 cable into the jack on the back of the
telephone labeled LINE.
6. Insert the other end of the cable into the
jack on the AC adapter labeled PHONE.
7. Insert one end of the RJ-11 line cord into
the jack on the AC adapter labeled LINE.
8. Insert the other end of this line cord into a
telephone jack.
9. Plug the AC adapter into an unswitched
electrical outlet.
10. Remove the plastic overlay and place the
paper faceplate (supplied separately) over
the keys. Replace the plastic overlay by
hooking the tabs on the overlay into the
recessed slots located on both sides.
11. Place the cordless handset on the base
unit. The handset/base registration
process will occur.
HANDSET/BASE REGISTRATION
PROCEDURE
This procedure establishes an exclusive link
between a specific handset and base, thereby
allowing no other access to this specific base.
To accomplish this procedure, place the handset
on the base in the charging position. The LINE
indicator will blink while the registration process
is occuring. This process only occurs the first
time a handset is placed on the charging cradle
of a new base.
