6
CELL ROUTE-GSM
Getting Started
Powering Up CellRoute-GSM
Note: The cellRoute-GSM unit must be connected to the mains power
and allowed to charge for a minimum of 30 minutes before use.
On power up the RED and GREEN LEDs will flash 5 times.
The Green LED will come on and remains on. The RED LED will light up for
approximately 10 seconds and then go out for approximately 10 seconds. Once
the unit has logged onto the GSM Network the Red LED will come back on.
Making a test call
Make a test call with the phone connected to the CellRoute-GSM. On
completion of dialled digits you will hear a confidence tone indicating the call is
successful. (Pressing the # key after the dialled digits results in a faster dial-
up.)
The RED LED will start to flash when the handset is lifted on the telephone-
indicating signal Strength. Once the call is connected the RED LED will flash for
45 seconds indicating signal strength then stop leaving both RED and Green
LED lit.
Number of flashes
Status
Signal strength (in dB)
0
None/Poor
<-81dB
1
Average
>-81dB & <-67dB
2
Good
>-67dB & <-59dB
3
V- Good
>-59dB
It is possible to Set Incoming & Outgoing volumes on CellRoute
Outgoing volume adjustment on microphone
To adjust the microphone level
•
Lift the receiver
•
Dial 0##6
•
Dial 1 to 5 followed by # (1 sets lowest volume, 5 sets highest volume)
You will hear an acceptance tone once the digit has been dialled.
Incoming volume adjustment on speaker
To adjust the Speaker level
•
Lift the receiver
•
Dial 0##3
•
Dial 1 to 5 followed by # (1 sets lowest volume, 5 sets highest volume)
You will hear an acceptance tone once the digit has been dialled.
