15
Problem
Solution
At power-on, the control unit does not move the motors and emits no warning.
The system needs to be programmed, see section
2
.
L3
flashes and an intermittent sound starts after configuration.
Repeat the procedure. At the end of it
DO NOT
change the
DIP4-5
setting.
The configuration procedure does not start upon pressing
P1
and
P2
twice.
P1
and
P2
must be pressed simultaneously. There must be no more than 1 second
between pressing the first and the second time.
During the manual movement test in the configuration procedure, the motors do
not stop automatically at the limit stop.
Change the current threshold (section
2.4
) before continuing with configuration.
There’s no continuous beep during transmitter memorization.
There must be no more than 1 second between pressing the buttons.
It is impossible to memorize a transmitter.
The radio code is already memorized or the memory is full.
After configuration, the engine stops and invert the direction.
Remove any obstacles that block the movement.
The motor stops or there is abnormal functioning of the motor.
Check the encoder signal wiring.
6.1
TROUBLESHOOTING (what to do IF…)
In the event of a defective control unit, if the provided memory (see below) is
still working and the revision of the board is > 9.x, it may be replaced without
losing the configuration parameters.
To do this, the control unit must not be powered:
• insert the memory card of the defective control unit into the new one;
• set the DIP switches of the new control unit as they were in the old one;
• switch the system on.
6.2
Replacing the control unit
6.3
Quick learning of limit switch
If the following have been already programmed
• motor control mode
• the correct motor direction
• at least one transmitter for each of the independent motor output
• current threshold to be applied
it is possible to carry out the SELF-LEARNING OF LIMIT SWITCHES
without
accessing the control unit
.
complete
closing
complete
opening
complete
closing
complete
opening
...
...
...
...
• Pergola with 2 synchronized motors:
Together
MOTOR 1
and
MOTOR 2
• Pergola with 2 independent motors:
MOTOR 1
first, then
MOTOR 2
Test the movement and the direction of the motors by
means of the memorized transmitter, after this keep the
button
P3
of the transmitter pressed for
10 s
.
Memorized
P3
( 10 s)
M1
M2
Memory
Summary of Contents for TVPLA868CC2EN
Page 91: ......