Teleco FlatSat Elegance, Installation Manual

Page: 12 / 36

11
Complete Kit with Black Box, Sat Decoder and TV
This configuration will allow you to:
• control your Black Box, TV and DECODER with ONE remote control. You can switch
the whole system on and off via one button.
• control all the three devices via the remote control using the infrared TV sensor.
The following Kits are available:
Complete Kit with Sat FORCE HD CI+ receiver and 19" Teleco United TV
Complete Kit with TivuSat DS510M receiver and 19" Teleco United TV (Italy only)
Complete Kit with TNT SD M6000 receiver and 19" Teleco United TV (France only)
Complete Kit with TNT HD M5200/M7000 receiver and 19" Teleco United TV (France only)
Connection diagrams
16) Connect the grey cable (motors) to the MOTOR UNIT connector and the white coaxial
cable (antenna) to the LNB connector of the Black Box.
17) Connect the BLACK cable of the Black Box to the NEGATIVE POLE of the vehicle 12
Volt Battery and the RED cable to the POSITIVE POLE + (remember not to mix
the + and - poles up), using 2 cables of 2.5 mm2 cross section.
18) The GREEN safety cable of the Black Box must be connected to Pin 15 of the vehicle
ignition key cylinder (D+). In this way, whenever the engine is started, this cable receives
a po12 Vdc voltage, which will automatically lower the antenna and lock all functions
of the Black Box simultaneously.
19) Connecting the Decoder
a) Connect the RECEIVER connector of the Black Box to the LNB input of the Decoder
via a coax cable.
b) Connect the RECEIVER IN connector of the Black Box to the Scart output of the
Decoder via a Scart cable.
c) Connect the IR Receiver connector of the Black Box to the IR connector of the
Decoder via a jack-jack lead.
20) Connecting the TV
a) Connect the TV SCART connector of the Black Box to the Scart input of the TV via a
Scart cable.
b) Connect the "IR TV" connector of the Black Box to the "IR" connector of the TV via
a jack-jack lead.