Fig. 37:
Location of the SATA connector and standoffs for the hard disk
(5)
Screw the hard disk supplied to the auxiliary metal plate.
(6)
Connect the hard disk and place the metallic flange carefully over the standoff posts located in the device
chassis. This operation must be carried out carefully, without forcing any piece or part of the device.
(7)
Screw the plate to the posts using four screws. Firmly tighten them.
(8)
Close the device with the cover. Secure the cover with the screws.
(9)
Connect and switch on the device, as described in section
Connecting
on page 17. Should you detect any prob-
lems, switch off the device and make sure that the above steps have been carried out correctly. If the problem
persists, please contact your supplier.
(10) Check that, during startup, the HD LED located on the device’s front panel is flashing.
3.7.2 Procedure to install a flash memory expansion USB
To install a flash memory expansion USB, please follow these steps:
(1)
Switch off the device and remove the data cables, as described in section
Disconnecting
on page 17.
(2)
Remove the device from the workplace and place it in a stable, safe location where it can be easily accessed
and handled. Open up the device. To do this, you need to remove the top cover (secured through screws loc-
ated on the rear and side of the device).
(3)
Once the screws have been removed, slide the cover towards the rear panel and lift it. Place it in a safe loca-
tion.
(4)
Locate the USB connector for the flash memory expansion and connect the memory stick supplied.
3 Components and Power Supply
Teldat S.A.
24
ATLAS 6x/i6x NW Router
