4.10 FCC Statement
4.10.1 Federal Communications Commission Interference
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resid-
ential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception (determined by turning the equipment off and on), the user is encouraged to try to correct the in-
terference through one of the following means:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit that is different from the one used by the receiver.
• Contact the dealer, or an experienced radio/TV technician, for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
permission to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including in-
terference that may cause undesired operation.
This device and its antennas(s) must not be placed or operated in conjunction with any other antenna or transmitter,
except when done in accordance with FCC multi-transmitter product procedures.
4.11 IC Statement
4.11.1 CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, includ-
ing interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de li-
cence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est suscept-
ible d'en compromettre le fonctionnement.
This device and its antennas(s) must not be placed or operated in conjunction with any other antenna or transmitter,
except when done in accordance with IC multi-transmitter product procedures.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre
antenne ou transmetteur.
Teldat S.A.
4 Compliance
Teldat 4Ge Router
23
