Telcoma EVO1200, Operation And Programming Instructions

Page: 34 / 56

Radio antenna input
16
17 Braid
Control
Connection only necessary with receiver OC2 active.
Use aerials for frequency 433 MHz (50 Ohm)
Auxiliary device power supply
output
Gate open indicator light
Limit switch closed
Limit switch open
13
14
15
14
20
19 (com)
18
19 (com)
/
/
/
24ac/
300mA
24ac/
100mA
NC
NC
Power supply for receiver photocell, if the Fototest
function is used.
Signals gate status with different flashes.
Power supply for transmitter photocell, if the Fototest
function is used.
24Vac
(Tx FT)
5
4
GB
ELECTRIC CONNECTIONS
Make sure that the mains power supply has been disconnected and make the electrical connections.
Take care when stripping cables not to reduce the insulation between terminals or other metal parts.
After making the connections, check the tightness of screw terminals once more.
THE INSERTION OF AN external, Independent DISCONNECTING SWITCH (not supplied) of suitable capacity for the load Is
envisaged for the control unit power supply.
Flasher output
Courtesy light
OPENING command input
CLOSING command input
Photocell contact input
Input with selectable function
Stop command input
Step/step command input
Power supply
3
4
6
12 (com)
7
12 (com)
11
12 (com)
10
12 (com)
9
12 (com)
8
12 (com)
1
2
(L)
(N)
Function / Device Term. n.
/
/
/
/
/
/
/
/
/
/
230/0,5A
230/0,5A
NO
NO
NC
NO/NC
NC
NO
230/6A
V/I max
Switches on with motor in motion.
On form start of manoeuvre until 3 minutes after
complete shutdown.
Starts gate opening.
Starts gate closing.
Reverses direction during closure.
Connect this input to the common if it is not used.
See settings of dip-switches 3 and 4.
Blocks all functions.
Connect this input to the common if it is not used.
See settings of dip-switches 1 and 2.
Connect to 230 V line.
Notes
33