24
TMP800 Installation Guide
The following prompts are displayed:
Note
Each network interface (Eth0 and VoIP0) must be on a different subnet. For example, if
the netmask is 255.255.0.0 and the IP address of ETH0 is 192.168.1.10, the VoIP0 port
cannot be on any IP address starting with 192.168.x.x.
Prompt
Description
Adapter Name
Name of the Tmedia unit. This character string must uniquely identify the
Tmedia unit. The default value is the serial number of the Tmedia unit.
DHCP
Dynamic IP address is used when the Tmedia unit is started. Currently
not supported.
eth0/VoIP0: IP Address
When you are not using DHCP, the IP address is used as the static IP
address for ports Ethernet 0 (ETH1), and VoIP0 (VoIP1) of the Tmedia
unit.
eth0/VoIP0: NetMask
When you are not using DHCP, the network mask is used for ports
Ethernet 0, and VoIP0 of the Tmedia unit.
eth0/VoIP0: Gateway
When you are not using DHCP, the gateway address is used for ports
Ethernet 0 and VoIP0 of the Tmedia unit. If you are planning to use the
Tmedia unit in the same subnet as the host (i.e. you do not require
access to an IP address outside the subnet), then the gateway can be
set to '127.0.0.1’.
Active cfg
This allows a device to make use of multiple configurations.
autoboot: auto fpgaload
When set to “no”, the device will stop booting after initial bootup
sequence. This is used for debugging only, the default value is “yes”.
Boot timeout
This is used to set the time lapse between the initial bootup sequence
and the complete bootup. The default value for this setting is 5 seconds.
gateway port
(see previous page)
list of available Boot
directories
This enables the user to manually switch between available software
versions.
