Equipment Connections
11
2.3
Connecting to the Tmedia Control Network
The Tmedia Control network enables the Toolpack application and stream servers to control the
TMP800 using a Gigabit Ethernet switch.
2.3.1
Prerequisites
To connect the TMP800 to the Tmedia Control network, you will need:
•
Customer provided gigabit Ethernet switch.
•
One CAT5 Ethernet straight cable with RJ45 male-male terminations.
2.3.2
Interconnections
The TMP800 is connected to the Tmedia Control network by one Gigabit Ethernet network link, as
shown in Figure 2.2 on page 11.
To connect the TMP800 to the Tmedia control network:
1. Connect a CAT5 Ethernet straight cable with RJ45 male-male terminations to ETH1 at the rear of
the TMP800. Connect the other end of the same CAT5 cable to the Gigabit Ethernet switch.
Figure 2.2
Connecting to the Tmedia Control Network
Gigabit
Ethernet
Switch
ETH
ETH
1
2
RS-232
3
1
8
7
6
5
4
3
2
