Metrobility 10/100 AutoTwister 11
5
NOTE:
Be sure to properly set the MDI-II to MDI-X switch located between
the two port connectors. Refer back to
Once power is applied to the unit, correct connectivity can be verified via
the link (LK) LEDs if a device is connected to the remote end of the cable.
Apply Power
Power is applied to the AutoTwister from the desktop power supply. The
power supply is equipped with an S760 hollow-type plug for insertion into
the DC jack located on the back panel and the standard IEC 320-type AC
power receptacle. All standalone AutoTwister standalone units use a 90-
260V universal desktop power supply.
Connect the DC input jack located on the back of the AutoTwister before
connecting to the AC outlet.
Upon receiving power, the AutoTwister goes into normal operation mode
and automatically provides the appropriate signal translation between the
connected network segments.
Verify valid connections via the link (LK) LEDs on the AutoTwister’s front
panel.
PWR
DC INPUT/5VDC
OFF
ON
FD
1
AN
1
100M
1
LLR2
FD
2
LLCF
Figure 4.
