www.tekvox.com
1201-N+
79033-N+ User Manual
Output Adjust:
Adjust output image position (X: horizontal direction and Y: vertical direction),
ratio aspect (width and height), polarity adjustment (H Polarity and V Polarity) and output setting
(HDMI on/off and HDBT on/off).
Input 6 Selection:
Select video source format for VGA input, includes AV 1 (C-video signal), VGA
1 (VGA signal) and YPbPr 1 (Component video signal).
Baud rate:
Set the baud rate for Local and HDBaseT RS232 control: 2400, 4800, 9600, 19200,
38400, 57600, and 115200.
User EDID Load (USB):
Insert the USB flash disk with EDID file to FIRMWARE port to load EDID
data through this menu.
RESOLUTION:
Set the output resolutions: 1920x1200, 1920x1080, 1600x1200, 1600x900,
1360x768, 1280x800, 1280x720, and 1024x768.
Audio Mute Setup:
Turn on/off the Mix, HDMI 1, HDMI 2, HDMI 3, HDMI 4, HDMI 5, VGA audio.
IP:
Shows the current IP address.
Software Update (USB):
Insert the USB flash drive with updating file to USB port of the Scaler
Switcher in order to update the software through this menu.
5.7.2 Instructions for VGA Converting Cable
VGA inputs support YPbPr and C-video sources. The TEK 1201-N+ comes with 1 VGA converting cable
to comply with these signals. When you need to select these signals as an input source, switch to
channel INPUT 5 and set the signal type in OSD.
A.
Operation Examples:
1)
Via front panel buttons & OSD:
Press the
MENU
button on the front panel to enter into OSD. In the
OPTION
setting menu, set
“INPUT 5 Select” to
YPbPr
.
Via RS232 commands
:
Send command
50684%
to switch to YPbPr source.
2)
Via IR remote & OSD:
Press the
MENU
button on the IR remote to enter into OSD and enter into the
OPTION
setting
menu, set “INPUT 5 Select” to
YPbPr
source.
