Installation
Battery charge level
indicators
When the WFM200BA battery pack is not installed in the instrument, you can
check the charge level by pressing the Check button on the back of the battery
pack. LEDs will illuminate to indicate the amount of charge remaining in
increments of approximately 20%.
When a battery pack is installed in the instrument, the charge level meter is shown
on the bottom right of the status bar. The following table shows examples of the
meter icons.
Table 4: Battery charge-level meter icons
Item
Description
Battery fully charged, AC adapter plugged in
Battery partially charged, AC adapter plugged in and charging
Battery level low, AC adapter not plugged in
Battery level critically low, AC adapter not plugged in
24
WFM2200 Installation and Safety Instructions
Summary of Contents for WFM2200
