NOTE REGARDING FACTORY CALIBRATION PROCEDURES
AND TEST SPECIFICATIONS
Factory Calibration Procedures and Test Specifications are
intended for use at the factory as a general guide for calibrators
and quality control men. Most of the tolerances listed in these
sheets are closer than advertised specifications.
This is done pur
posely in order to insure that the instrument will meet or exceed
advertised specifications when it reaches the customer.
These calibration procedures and test specifications should
be used, therefore,
as
a guide only.
Some of the test equipment referred to in the calibration
procedures is not available commercially; the Tektronix field engi
neer will be glad to suggest alternate approaches.
1/ 16/61
C/S Copy
