Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−87
FACtory
Setting the oscilloscope to factory default has the following impact
on the programming interface:
H
Clears the Event Status Enable Register
H
Clears the Service Request Enable Register
H
Sets the Device Event Status Enable Register to 255
H
Sets the Power On Status Clear Flag to TRUE
H
Enables all Command Headers (HEADer ON)
H
Sets the macro defined by *DDT to a “zero-length field”
H
Clears the pending operation flag and associated operations
H
Performs the equivalent of DATA INIT
The FACtory command does not alter the following items:
H
State of the RS-232 or GPIB interface
H
Selected GPIB address
H
Front panel LOCK state
H
Verbose state
H
Display Contrast, TDS1000 and TDS2000 series only
H
Calibration data that affects device specifications
H
Stored settings
H
Stored waveforms or data
H
Hard copy parameters
H
Display messages language selection
Refer to Appendix B: Factory Setup.
*PSC, *RCL, RECAll:SETUp, *RST, *SAV, SAVe:SETUp
Syntax
Examples
Related Commands
Summary of Contents for TDS200 Series
