Model TRX-1100V-CONN 3-Slot Male HV Triaxial Cable Connector Instructions
6
071368600 / September 2019
To assemble the triaxial male HV connector and SC-22 triaxial cable:
1.
Slide the hex nut and V gasket onto the SC-22 triaxial cable as shown in the following figure.
Figure 9: Add hex nut and V gasket to triax cable
2.
Install the V clamp as shown in the following figure. Carefully seat the V clamp into the V gasket when
inserting. The sharp edge of the V clamp must split the gasket to seal properly.
Figure 10: Add V clamp
3.
Flare the exposed outer shield cable braid back over the V clamp, as shown in the following figure. Make
sure you trim the excess braid so it does not protrude from the connector.
Figure 11: Flare braid over V clamp