List of Figures
Figure 1: TIVP Series IsoVu Measurement System....................................................................................................................21
Figure 2: Maximum safe handling limits for common mode voltages between the sensor head and earth ground....................26
Figure 3: RF burn hazard zone around the sensor head............................................................................................................ 26
Figure 4: Connecting the sensor tip cable to the sensor head....................................................................................................29
Figure 5: Connect the sensor head to the bipod......................................................................................................................... 29
Figure 6: Probe Setup menu....................................................................................................................................................... 32
Figure 7: Typical CMRR values for the sensor tip cables........................................................................................................... 37
Figure 8: Maximum differential input voltage vs. frequency for the sensor tip cables.................................................................37
Figure 9: Differential input impedance vs. frequency for the sensor tip cables...........................................................................38
Figure 10: Sensor head...............................................................................................................................................................39
Figure 11: Sensor tip cable..........................................................................................................................................................39
Figure 12: Compensation box..................................................................................................................................................... 39
Figure 13: Block diagram............................................................................................................................................................ 40
Figure 14: Square pin series sensor tip cables........................................................................................................................... 41
Figure 15: Connecting to an adapter on the circuit board with the probe tip tripod.....................................................................41
Figure 16: Lining up the MMCX-to-0.1-inch (2.54 mm) adapter on the circuit board.................................................................. 42
Figure 17: Lining up the MMCX-to-0.062-inch (1.57 mm) adapter on the circuit board.............................................................. 42
Figure 18: Pushing the MMCX-to-0.062-inch (1.57 mm) adapter in place..................................................................................42
Figure 19: Pushing the MMCX-to-0.1-inch (2.54 mm) adapter in place......................................................................................42
Figure 20: Adapter clearance requirements................................................................................................................................43
Figure 21: Removing the header from square pins on the circuit board..................................................................................... 43
Figure 22: Using the soldering aide to install the square pins on the circuit board..................................................................... 44
List of Figures
TIVP Series IsoVuTM Measurement System User Manual
vii
