Tektronix DS1001, User Manual

Page: 129 / 130

Index
DS1000 Series User Manual
Index–5
setting the audio mode, 3–6
setting the noise threshold, 3–7
setting the sound trap, 3–7
setting ZCP, 3–5
status display, 2–6
Programming
command syntax, B–11
command types, B–5
remote flag, B–4
Programming model, B–3
PWD, remote command, B–24
Q
QUAD output, description, 2–3
R
Rackmounting, 1–7
available kits, 1–7
Rear panel, description of features,
2–3
RECPRT, remote command, B–25
Reference section, 3–1
Remote address, for RS485 proto-
col, B–4
Remote control, B–1
command descriptions, B–13
command syntax, B–11
command types, B–5
programming model, B–3
remote flag, B–4
sending and receiving data, B–5
Remote flag
DISC remote command, B–18
RS485 protocol, B–4
Remote operation flag, RS485
protocol, B–4
Replacing the fuse, C–2
REPORT, remote command, B–26
RF input
description, 2–4
signal strength, 2–5
RS232
configuring, 3–8
handshaking, 3–9
protocol settings, B–2
RS485
configuring, 3–8
device address, B–4
remote address, B–4
setting address, 3–8
special byte codes, B–3
termination, 3–9
S
Safety certification and compliance,
A–6
Safety standards, A–7
SCL protocol, B–3
Self tests, at power on, 1–5
Sending and receiving data, B–5
Serial
addresses for RS485, B–3
baud rate, B–2
command descriptions, B–13
command syntax, B–11
command types, B–5
configuring the port, 3–8
pin assignments for port, B–2
port connections, B–1
port protocol, B–2
programming model, B–3
rear panel connector, 2–3
remote flag for RS485, B–4
RS232 handshaking, 3–9
RS485 special byte codes, B–3
RTS/CTS handshaking, 3–9
selecting the mode, 3–8