Command Groups
Table 2-32: Trigger Commands (cont.)
Command
Description
Returns the trigger frequency
in hertz, if available
Returns the current state of
the triggering system
Vertical Command Group
Use the commands in the Vertical Command Group to control the vertical setup of
all live (channel) waveforms for acquisition and display of channel, reference,
and math waveforms.
Table 2-33: Vertical Commands
Command
Description
Returns auxiliary input parameters
Returns all information concerning the probe
attached to auxilary input
Sets the TekVPI probe attached to the
auxiliary input to autozero
Sets the state of the speci
fi
ed probe control
Starts a degauss/autozero cycle on a TekVPI
current probe attached to the auxiliary input
Returns the degauss state of the TekVPI
current probe attached to the auxiliary input
Sets or returns the range of the TekVPI probe
attached to the auxiliary input
Sets or returns the gain factor of the probe
that is attached to the auxiliary input
Returns the serial number of the probe that
is attached to the auxiliary input
Returns the type of probe that is attached to
the auxiliary input
Returns the resistance of the probe that is
attached to the Auxiliary input
Sets or returns the input bypass setting on
VPI probes that support input bypass
Returns the units of measure of the probe
that is attached to the auxiliary input
Returns vertical parameters for the speci
fi
ed
channel
2-60
MSO4000 and DPO4000 Series Programmer Manual
Summary of Contents for DPO4000 Series
