![background image](http://html1.mh-extra.com/html/tektronix/067-0484-02/067-0484-02_instructions-manual_1077877027.webp)
Deskew and Gain Cal Fixture Instructions
Deskew Fixture Instructions
19
7.
Touch the
Calibrate Probe
button.
8.
When the routine is finished, remove the connections from the deskew
fixture.
Perform the following procedure to check calibration status:
1.
From the tool bar, touch the
Vertical
button to display the oscilloscope
Vertical setup
control window.
2.
Touch the Probe
Cal
button to display the vertical Probe Cal control
window.
3.
Select the oscilloscope channel to which the probe is attached.
4.
Check the Probe Status readout:
H
Initialized: indicates that the probe has not been calibrated on the
selected channel.
H
Pass: indicates that the probe has been calibrated on the selected channel.
H
Fail: indicates the probe has not been calibrated, repeat gain cal
procedures.
NOTE
. Probes without a TekProbe interface cannot be calibrated.
5.
Touch the Help button to access the online assistance.
End of procedure
Check the calibration
status