via GIUSEPPE DI VITTORIO 9
20037 PADERNO DUGNANO (MI) ITALY
CONTACT US: (+39) 0291082905 - WWW. TEKSET.IT
| RENT: LASER |
R
. . .
via NAZARIO SAURO 13/A
20037 PADERNO DUGNANO (MI) ITALY
CONTACT US: (+39) 0291082905 - WWW. TEKSETRENATAL.IT
| LASER |
Manual: RTI NEO ONE
page 5 / 48
13. Never use dimmer, RC or other electroni-
cally switched sockets. Whenever possib-
le, do not use the laser projector together
with large appliances (especially fog ma-
chines) on the same mains!
14. Ensure sufficient ventilation and do not
place the device on any warm or heat ra-
diating surface. Especially the ventilati-
on openings must not be covered!
15. Ensure that device does not get over-
heated. Make sure that the device is not
exposed to spotlights (especially moving
heads). Heat of spotlights could overheat
laser in a little while and leads to a degra-
dation of performance.
5. Service Notes
• Moisture and heat can reduce lifetime of
the laser system dramatically and expires
any warranty claim.
• Quick on/off switching of this device will
reduce durability of the laser diode dra-
matically.
• Avoid sharp knocks and shocks to this
device and ensure sufficient protection
during transportation. Look after your La-
serworld product.
• To increase durability of your laser,
protect device against overheating:
-
Always ensure sufficient ventilation.
-
Do not face spotlights (especially mo-
ving heads) to the device.
-
Check temperature after approx. 30
minutes with each new installation.
If necessary install the projector at a
place with different temperature.
-
Keep the device dry. Protect it from
moisture, rain and damp.
-
Switch off device when it is not nee-
ded. Diodes are switched on and can
wear out even if there is no visible la-
ser output.
• Removal of the warranty label as well
as damages to the device caused by
improper handling, neglect of the sa-
fety instructions and service notes will
void the warranty.
4. Working on the Device
1. This product has no user serviceable parts inside and should only
be maintained and serviced by a qualified engineer.
2. Be sure that the mains plug is not connected to the power
supply while installing the device.
3. Take off all reflecting things like rings, watches etc. befo-
re starting to work with or at the projector.
4. Only use non-reflecting tools to work on device.
5. Wear protective clothing (like goggles, gloves etc.) according to laser power
and wavelength of the laser.
Manual: RTI NEO ONE
page 6 / 48
6. Warnings and other Notices on the Device
Laser radiation!
Avoid exposure
to beam
Laser class 4
Caution of
radiation if co-
ver is removed
Power supply
& consumption
Model type
Wavelength
Output power
Production year
Only for indoor use!
LASER RADIATION
AVOID EYE OR SKIN
EXPOSURE TO DIRECT OR
INDIRECT RADIATION
CLASS 4 LASER PRODUCT
DIN EN 60825-1: 2014
CAUTION OF RADIATION
IF COVER IS REMOVED
445nm - 655nm
3‘300 - 3‘600mW
320
RTI NEO ONE RGB
YEAR:
λ =
P =
VOLTAGE: 24V DC | Power: W
IEC protection (isolation) class 1 appliance
Ray Technologies GmbH, Mühlbachweg 2, 83626 Valley, Germany
Model:
Warning! Read user manual before use.
Operation by qualified personnel only.
Never point laser beam at people.
Never look directly into the beam.
