123-1018-001
8
3.
While firmly holding the tool, remove the 2 locking nuts
by hand.
Carefully slide the spring cover and spring (along with the
supplied tool) away from the headstock casting.
Caution:
By sliding the spring out from its position, it will try to
uncoil itself therefore the tool must be held firmly by
hand to prevent the spring uncoiling in an uncontrolled
manner.
When you feel the spring uncoiling itself, slowly turn the
tool towards that direction until the spring uncoils itself
completely.
When the spring is completely uncoiled, it is safe to
simply slide the spring away from the headstock casting.
4.
Once the spring is removed, the handle assembly can be
removed by pulling it out from the headstock casting.
Note:
It would be a good idea to put the drill press table right up
to the spindle to eliminate any risks of the spindle falling
straight out from the headstock casting.
5.
On the NOVA Vulcan and compatible models of the NOVA
Voyager, a mounting hole is located inside the part where
the original handle was inserted.
Take the positioning pin included in this package and
insert it into the top location hole. You may require a tool
such as a centre punch to punch the positioning pins into
place.
Note:
The bottom location hole should be used when the top
location hole is not available for any reason.
