123-1018-001
10
7.
Attach the down feed handle to the housing and secure it
by using the grub screw. Remember to insert the small
key into the shaft slot before sliding the handle onto the
shaft.
Then slide the down feed shaft into the housing.
Note:
The shaft might be difficult to slide in because of the
worm gear inside. To slide the shaft in, try slowly rotating
the handle clockwise while wriggling the shaft.
Do not force the shaft into the housing as it may cause
damage to the internal gears.
8.
Attach the spring back onto the shaft.
Insert the centre of the spring into the slot machined on
the shaft. Place the cover over the top of the spring, make
sure to have the tongue slotted into the cover slot.
Using the included tool, turn the spring approximately 3/4
turn and push it into the screw located on the bottom.
While holding the tool and spring firmly, screw on the 2
locking nuts until finger tight. Carefully remove the tool
from the spring and spring cover, making sure that the
spring does not uncoil.
