1
The hotplate that is to be controlled must
have been already selected. The corres-
ponding decimal point (13) has to be lit.
2
Touch the clock sensor
(7).
3
Use the
or
sensors (5/4) to alter
the time.
Disconnecting the clock
When the time that was programmed for
the hotplate elapses, a series of beeps will
sound for at least a minute.
To stop the beeping, touch any sensor.
The hotplate will now be disconnected.
If you wish to stop the clock before the
time that you programmed has elapsed:
1
The hotplate that is to be controlled must
have already been selected. The corres-
ponding decimal point (13) has to be lit.
2
Touch the clock sensor
(7).
3
Use sensor
(4) to reduce the time.
The clock will have been cancelled, but
the hotplate will still be active until you
switch it off.
Switching off rapidly
1
The clock must have already been selec-
ted. The corresponding decimal point
(13) has to be lit.
2
Touch sensors
and
(5 and 4)
simultaneously and the clock will be dis-
connected. The clock's indicator will stay
turned on, but it will serve no purpose.
MODEL TC 620 AND TR 735 AB
On these models, you can use the clock as
a counter for periods of between 1 and 99
minutes, and as a hotplate timer for times
of between 1 and 99 minutes. All the coo-
king areas can be programmed indepen-
dently and simultaneously.
Timing a hotplate
1
The cooking area that is to be timed has
to be selected. The corresponding deci-
mal point (13) has to be lit.
2
Select a power level of between
1
and
9
using the
or
sensors (5-4).
3
Touch the clock sensor
(7). The deci-
mal point (13) of the time indicator (8)
(which shows
00
) will come on, and it
will flash on and off along with the con-
trol indicator (11) of the corresponding
area.
4
Touch the clock sensor
(7) again to
increase the value of the time you wish
to set, or
(4) to decrease it (from 1 to
99 minutes). You can keep your finger
on the
or
sensors (7/4) to make
the minutes pass by automatically and
make your selection more quickly.
The clock will begin to control the time
automatically. The control indicator (11)
that corresponds to the timed area will
then stay lit up.
When the chosen time elapses, the timed
area will disconnect and the clock will
sound a series of beeps for several
seconds. The time indicator will show
00
and this will flash on and off, along with the
control indicator for the area that has dis-
connected.
If the cooking area that has been switched
off is hot, its indicator will show a
H
, other-
wise it will show a
0
. Touch any sensor to
disconnect the beeping signal.
GB
29
