GB
38
If something doesn’t work
Before calling the Technical Service, please
make the following checks:
Fault
Possible cause
Possible solution
Message ER 21 on the control and subsequent disconnection
If, whilst cooking, the tempe-
rature of the control electro-
nics gets too high, it will dis-
connect to avoid damage.
Overheating problems only
occur while cooking under
extreme conditions of use
(cooking for a long time at
full power).
Leave the hob to cool
down for a few minutes. If
the problem persists, check
that installation was perfor-
med in compliance with the
instructions in this manual.
Message ER 25 and the beeping signal
Surges in the electricity
supply network
Contact the Technical
Service
Message ER 03 on the control and the beeping signal. Control disconnection
There is an object or liquid
covering up the touch
control.
Remove the object or liquid
that is covering the touch
control.
FOR ALL THE MODELS:
MODELS TT 600, TT 630, TB 600, TR 600, TC 620 and TR 735 AB:
Neither the hotplates nor the pilot lights are working
The cable is not connected
to the mains
Connect the cable to the
mains
The pan is sticking to the glass
Something has melted
between the pan and the
glass.
Pans with aggressive bases.
Set the hotplate to full power
and try to unstick it.
Check the bases of your
pans and do not slide them
across the glass.
The control is blocked.
Follow the instructions to
unblock the control.
A L appears on the control and it does not work
