Teka EW 90 5G AI AL TR CI E1-ME, Instructions For The Installation And Advice For The Maintenance

Page: 5 / 76

5
CLEANING
IMPORTANT:
always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
2) HOT PLATE
Periodically wash the hot plate, the enamelled stell
pan support, the enamelled burner caps “A”, “B”
and “C” and the burner heads "T" (see fig. 6/A and
6/B) with lukewarm soapy water. They should also
be cleaned plugs "AC" and flame detection "TC"
(see fig. 6/B). Clean them gently with a small nylon
brush as shown (see fig. 6) and allow to dry fully.
Do not wash in the dishwasher.
Following this, all parts should be thoroughly
rinsed and dried. Never wash them while they are
still warm and never use abrasive powders.
Do not allow vinegar, coffee, milk, salted water,
lemon or tomato juice from remaining in contact
with the enamelled surfaces for long periods of
time.
WARNINGS:
comply with the following instructions, before
remounting the parts:
- check that burner head "T" (fig. 6/B) slots
have not become clogged by foreign bodies.
- Check that enamelled burner cap “A - B - C”
(fig. 6/A - 6/B) have correctly positioned on
the burner head. It must be steady.
- The exact position of the pan support is
established by the rounded corners, which
should be set towards the side edge of the
hot plate.
- Do not force the taps if they are difficult open
or close. Contact the technical assistance
service for repairs.
- Don’t use steam jets for the equipment
cleaning.
FIG. 6/B
FIG. 6 FIG. 6/A
FIGURAS 1
Note: continuous use could cause the
burners to change colour due to the high
temperature.