Tek-Trol TEK-LCD 7800A-0L1, Instruction Manual

Page: 25 / 36

Display Parameter Action/Setting
FILTER
Filter Set noise filter
LO
Filter Low Set noise filter to low setting
nmED
Filter Medium Set noise filter to medium setting
HI
Filter High Set noise filter to high setting
OFF
Filter Off Disable noise filter
VOLSCAL
Volume Scale Scale the volume display
vOl
DECIMAL
Volume Decimal Set the decimal position for volume scaling
NO PTS
Number of Points Set the number of points for volume scaling
INPUT 1
Input 1 Set volume input 1 on the level display
DSPLY 1
Display 1 Set volume display 1
INPUT 2
Input 2 Set volume input 2 on the level display
DSPLY 2
Display 2 Set volume display 2
SAVE ?
Save Save entered volume scale parameters
LVL CAL
Level Calibration Calibrate the level display
INPUT 1
Input 1 Calibrate input 1 value
DSPLY 1
Display 1 Set display 1 feet and inches
INPUT 2
Input 2 Calibrate input 2 value
DSPLY 2
Display 2 Set display 2 feet and inches
SAVE ?
Save Save entered calibration parameters
ICAL
Internal Calibration Enter internal reference calibration
4.000
4.000 mA Calibrate input at 4 mA
20.000
20.000 mA Calibrate input at 20 mA
Error
SPAN
Error Span Error with calibration point 1 and 2 span
MULTIPT
Multipoint Set level display multipoint linearization
DISABLE
Disable Disable multipoint linearization
ENABLE
Enable Enable multipoint linearization
INFO
Meter
Information Show software number and version, or reset to
factory defaults
SOFT
Software Software number
ver
Software Version Software version
DFALTS?
Reset Defaults Restore factory default parameter settings