TEK Biomasse EBONY, Instruction Manual

Page: 5 / 32

5
Do not make electrical connections with
temporary or non-insulated cables.
Check that the equipment ground connection is
effective.
Before starting the unpacking and assembling or
disassembling of the stove, the Technician must
take the safety measures prescribed by law, with
special attention to those mentioned below:
• Ensure that the equipment installation site
complies with all national and European
regulations/laws;
• Ensure the use of all personal protective
equipment;
• Make sure that the workplace is in a safe
condition to perform the installation;
• To perform the installation, the installer
must be in full psychophysical conditions;
• No work should be carried out under
adverse conditions.

During maintenance operations, the
technician must carefully observe the following
instructions:
• Maintenance should only be carried out by
qualified personnel, at least once a year;
• Check that the stove is cold before
carrying out any type of work;
• Disconnect the equipment from the
electrical
current before starting
maintenance work;
• Use personal protective equipment and/or
other means of protection;
• All electrical and mechanical components
guarantee the correct functioning of the
stove, so they can only be replaced by
original components purchased from the
brand's technical assistance;
• The equipment must be taken out of
service if any safety component is
defective or out of calibration.
On water models, the installer must inform
the user of the following:
• In case of water leaks, it is necessary to
turn off the water supply and immediately
notify technical support.
• System pressure operation must be
checked periodically.
2.2. User
Before using for the first time, the user must read
this manual in its entirety and bear in mind the
following:
• Immediately disconnect the equipment
from the power supply in the event of a
breakdown or malfunction;
• The power plug must be easily accessible;
• When in normal operation, never
disconnect the appliance from the
electrical supply;
• If you are not going to use the stove for a
long period of time, disconnect the power
and remove the pellets from the hopper;
• After a more or less prolonged downtime,
the stove should be regularly serviced;
• The stove must not be switched on without
having carried out the daily maintenance
and/or inspection as referred to in point
9.2.1- Daily ;
• This stove does not work with wood, use
only 100% wood pellets as fuel according
to the manufacturer's recommendations.
See point 5.1- Fuel characteristics;
• This equipment is not an incinerator
do not use foreign substances as fuel;
• It is forbidden to operate the equipment
with the door open or with broken glass,
or even to open the door with the
equipment in operation;
• The equipment lights up automatically, so
you should not use any product to light the
stove, especially flammable liquids;
• When in operation, the stove has very hot
surfaces, so you should not approach or
touch them, with special emphasis on the