TEK Biomasse EBONY, Instruction Manual

Page: 18 / 32

18
9.
M
AINTENANCE
9.1. Security measures
Before starting maintenance work, make sure
that the stove is disconnected from the electricity
supply, that the stove is cold and the ashes are
out.
Turn off the main power switch located on the
rear panel, right side, and the corresponding
cable.
Use suitable cleaning equipment.
It is recommended to use a vacuum cleaner
suitable for ash.
9.2. Maintenance to be carried out
by the user
9.2.1. Daily cleaning
Due to the accumulation of ash in the brazier in
your equipment, which may cause failure to light
or lack of performance, it is necessary to clean it
daily.
Carefully clean the brazier, ensuring that all holes
are clear.
It is natural for “stone” to form at the base of the
brazier, this phenomenon largely depends on the
quality of the pellets used.
Figure 9- Brazier
Put the brazier back in place ensuring the perfect
alignment of the resistance hole with the
respective resistance. Incorrect alignment can
cause ignition failure.
9.2.2. Weekly cleaning
Glass cleaning
Wait for the glass to be completely cold,
otherwise it will break. The weekly cleaning of the
glass should be done with a damp cloth or paper
mixed with a little ash rubbing until it is clean.
You can use special products or foams for
neoceramic glass by placing it directly on a cloth
or paper, but never projecting it directly onto the
glass.
IMPORTANT, do not let the product run into the
metal parts as it will cause corrosion and quickly
deteriorate your stove.
Ash cleaning
The cleaning of the compartment that houses the
ash box must be carried out from week to week
or when necessary.
To clean it, it is necessary to remove the ash box
using the process explained below.
The compartment must be cleaned using an ash
vacuum.