VERY IMPORTANT:
Before opening your boiler, ensure that there is no more steam left inside by pressing the steam control
button located under the handle of the iron and keep pressed down
until there is no more steam 7 .
5 - FILLING THE BOILER WHILE IN USE
(when the boiler is empty)
8 - PUTTING YOUR STEAM GENERATOR AWAY
6 - MAINTAINING YOUR GENERATOR
7 - RINSING OUT THE BOILER
Never unscrew the boiler cap while the iron is producing steam.
1. Press the on/off switch to stop the generator.
2. Disconnect the generator from the mains.
3.
Slowly
unscrew the boiler cap (note: some hot steam may still escape).
4. Using a water jug, fill with one litre of tap water.
5. Fill the boiler, taking care that the water does not spill over.
If this occurs, remove the excess water.
6. Replace the boiler cap, screwing on tightly, reconnect your generator to the mains, and switch it on.
7.Wait a few minutes until the boiler heats up.
The generator and the iron are ready to use when both the iron’s thermostat light and the “steam ready” indicator go out.
• Before cleaning, ensure that the appliance is unplugged and that the soleplate and the iron
rest have cooled down.
• Do not use any cleaning or descaling products for cleaning the soleplate or the boiler.
• Never hold the iron or the base unit under the tap.
• Do not place the iron on a metal rest as this could damage it.
Place it on the iron rest on the base: it has non-slip pads and has been designed to withstand
high temperatures.
The iron soleplate:
regularly clean the soleplate with a damp, non-metallic washing up pad.
The base unit:
clean the plastic parts occasionally with a slightly damp cloth.
1. Check that the generator is cold and unplugged for more than 1 hour.
2. With a jug, fill the boiler 3/4 full with tap water.
3. Shake the base unit for a few moments and then empty it completely over a container .
To obtain the best results, we advise you to repeat this operation.
8
Be careful:
• To extend the life of your boiler and to avoid the building up of scale, it is essential that
you rinse out the boiler after every 10 uses. If your water is hard, increase the frequency.
• In particular, do not use descaling agents for rinsing out the boiler, as they could
damage it.
1. Press the on/off switch to stop your generator and unplug it.
2. Place the iron on the iron rest plate.
3. Leave the iron (and the iron rest) to cool down for 30 minutes.
You can now store your steam generator.
