STEP 4
Assemble Table Bed to A-Frame
• Face the front of the A-Frame where the Crossbar is located
(Figure 15).
• Grasp both Roller Hinges, right above the Cam Lock, and lift the
Table Bed. Allow the top of the Table Bed to rotate toward the
floor so that the back of the Table Bed is now facing you and the
top of the Table Bed is in front of the Crossbar (Figure 16).
• Lower each Roller Hinge Pivot Pin into the A-Frame hinge plates
one side at a time (Figure 20). The Self-Locking Hooks will open
to allow the Pivot Pin into the Hinge Plate slot, then automatically
snap closed over the Pivot Pin.
TIP:
You may need to push outward on the Hinge Plate in order
for the second Pivot Pin to lock in place.
• Make sure that each Pivot Pin is seated at the base of the slot in
the Hinge Plates and that the Self-Locking Hooks have closed
over both Pivot Pins (Figures 17 and 18).
Failure of the Self-Locking Hooks to close over both Roller
Hinge Pivot Pins is an indication of improper assembly and if
not corrected could result in serious injury or death!
WARNING
!
• Rotate the Table Bed into the use position (Figure 19). Ensure
that it rotates smoothly. See also Image A on Page 12 to
ensure correct assembly.
FRONT
REAR
FIGURE 17
FIGURE 18
FIGURE 15
FIGURE 16
FIGURE 19
For All Models
9
