Teeter FitSpine LX4, Assembly Instructions Manual

Page: 10 / 20

STEP 3
Assemble Roller Hinges to Table Bed
UNLOCKED
Bracket Pin Cam Lock Pivot Pin Bracket
C B A
UNLOCK LOCK
LOCKED
FIGURE 10
FIGURE 11
FIGURE 12
FIGURE 14
FIGURE 13
NEVER disassemble the Roller Hinge Pivot Pin.
WARNING
!
• For ease of assembly, rest the Table Bed against the Crossbar
(Figure 11) at the front of the A-Frame.
• On one side of the Table Bed, lift and hold the Cam Lock up all
the way to unlock (Figure 12).
• In your other hand, hold one Roller Hinge near the Pivot Pin. With
the Pivot Pin facing out (away from the Table Bed), slide the bottom
of the Roller Hinge between the Cam Lock and th e Bracket.
TIP: Make sure that the Cam Lock is completely open when
inserting the Roller Hinge, otherwise assembly will be more
difficult.
• Engage one of the holes in the Roller Hinge over the Bracket
Pin. Figure 14 shows the Roller Hinge installed correctly, with the
Bracket Pin engaged in Setting C.
NOTE: Refer to the Owner’s Manual for an explanation of the
hole settings. If you are unsure, use Setting C to start.
• Push down on the Cam Lock (Figure 13) to lock it and secure
the Roller Hinge.
• Repeat on other side. Make sure the Roller Hinges are in the
same hole setting on both sides.
NOTE: Some models come with Traction Handles pre-assembled
to the Roller Hinges. The assembly instructions detailed below
still apply.
• Familiarize yourself with the 3-Hole Roller Hinge and Cam Lock
terms (Figure 10).
For All Models
8