Traction Handles
Chrome Shaft
REAR
FRONT
Traction Handles
Leg Support
Housing
STEP 3
ASSEMBLE LAP PAD TO LAP PAD FRAME
Figure 3
Locate the Lap Pad Assembly Hardware Kit (D11020).
Figure 3:
In this step, you will only use the four (4) small
screws . With the Lap Pad face down, rest the Lap Pad
Frame on top of the Lap Pad . Make sure the Traction
Handles are pointing up and the Leg Support Shaft
Housing rests inside the indented area of the Lap Pad .
Align the screw holes . Insert the screws through the holes
and tighten with the Screwdriver .
6
Locate the Lap Pad Assembly Hardware Kit (D11020).
Figure 4a-4b:
You will use the remainder of the Lap Pad
Hardware Kit (D11020) from Step 3 . Thread the Hex Bolt
through a Flat Washer and Spacer . Make sure the small
end of the Spacer faces away from the head end of the
Hex Bolt . With the Traction Handles facing the rear of
the Base Assembly, place the Lap Pad Assembly over the
Chrome Shaft of the Base Frame and align the holes .
Insert the Hex Bolt with Flat Washer and Spacer through
the holes to secure the Lap Pad Assembly to the Chrome
Shaft . Thread the remaining Spacer (with the small end
facing the Chrome Shaft) and Flat Washer onto the end of
the Hex Bolt .
Figure 4b:
Fasten the Hex Nut using the wrenches
provided . Make sure the fasteners are securely tightened
and the Lap Pad rotates smoothly .
STEP 4
SECURE LAP PAD TO BASE ASSEMBLY
Figure 4a
Figure 4b
Screws x4
Bolt x1
Washer x1
Spacer x1
Spacer, Washer,
Hex Bolt x1
