DEX II
TM
Assembly Instructions LD-2000 Pg. 2
ASSEMBLY INSTRUCTIONS
ASSEMBLY
Figure 3
Figure 3A
Chrome
Shaft
STEP THREE
Secure the Lap Pad Assembly (H1-2005) to the Chrome Shaft of
the Base Frame Assembly
•
Remove the Hex Nut (H1-1304), Flat Washers (H1-1302) and
Spacers (H1-2017) from the Hex Bolt (H1-1412).
Keep this
hardware nearby.
•
With the Traction Handles facing the rear of the Base Frame
Assembly, place the Lap Pad Assembly over the Chrome Shaft in
the Base Frame and align the holes.
(See Figure 3)
•
Thread the Hex Bolt through a Flat Washer and Spacer. Make
sure the small end of the Spacer faces away from the head end
of the Hex Bolt.
•
Insert the Hex Bolt with Flat Washer and Spacer through the
holes, securing the Lap Pad Assembly to the Chrome Shaft.
Thread the remaining Spacer with the small end facing the
Chrome Shaft and tighten with the Flat Washer and Hex Nut.
(
See Figure 3A for close-up view)
•
Make sure the fasteners are securely tightened and the Lap Pad
rotates smoothly.
STEP ONE
Assemble the Feet (D1-1012, D1-1013) onto the Base Frame (H1-2009)
and the Legs (H1-2010)
•
Slide the Base Frame Feet (D1-1012) on to the Base Frame.
(See
Figure 1A)
•
Slide the Leg Feet onto the end of the Legs with the cane handle.
(See Figure 1B)
•
Push firmly on all four feet to ensure they are fully mounted.
Leg Housings
Traction
Handles
(Rear)
(Front)
STEP TWO
Attach the Legs (H1-2010) to the Base Frame (H1-2009)
•
With the cane handles facing upward, insert the Legs into
the Leg Housings of the Base Frame until the two holes in
the Leg Housing align with the holes at the top of each
Leg.
(See Figure 2)
•
Insert a Threaded Bolt (H1-2011) from the inside of the
Leg Housing through the holes on each column. Finish
on the outside of the Base Frame using the Flat Washer
(H1-2013), Lock Washer (H1-1301) and Bolt Cap
(H1-2012) and tighten with Wrenches (H1-2014).
Figure 2
Figure 1A
Figure 1B
