iii
98-05342 R1 EN
UniPilot
®
Pro
• It is not allowed for an unauthorized person to use or operate
the UniPilot Pro system.
•
Before starting work activities, the operator must have sufficient
knowledge of procedures how operate the UniPilot Pro system
in a safe manner.
• When installing the UniPilot Pro system, all safety precautions
must be taken into account and it should not be used if there
are any parts loose, missing or damaged.
• Only an operator who has been trained or is experienced may
operate the UniPilot Pro system.
• Before using the UniPilot Pro system all functions must be
checked and controlled for their correct working order. When
there is any doubt, do not take any risks always consult an
expert.
• Before operating the UniPilot Pro system, control all functions
of the Presence Switch and confirm the settings to ensure it
functions correctly.
• Turning the UniPilot Pro system on and off must always happen
consciously following the correct prescribed procedures.
• If an abnormal phenomenon presents itself, for example
excessive vibrations or noise, then immediately turn off the
UniPilot Pro system and consult a responsible expert.
• When the UniPilot Pro system is being cleaned or when
maintenance takes place, it must be totally turned off and free of
any electrical currents.
• The operator of the UniPilot Pro system must have complete
knowledge about how to react in case of emergency.
• A trained expert must always carry out maintenance or repairs
on the UniPilot Pro system.
• During repair or replacement of components on the UniPilot Pro
system only original components must be used.
• Always wear correct prescribed personal protection equipment
during the use or cleaning or maintenance of the UniPilot Pro
system.
• Always use the recommended cleaning materials and
accessories when the UniPilot Pro system is cleaned.
• Every unsafe condition or situation on the UniPilot Pro system
must be reported to the responsible persons.
• Do not leave or place objects on or in the area of the
UniPilot Pro system.
Warning Alerts
The UniPilot Pro system installer and manufacturer disclaim any responsibility for damage or physical harm caused by the failure to adhere to
the following safety requirements:
• As the operator of the vehicle, you are responsible for its safe operation.
• The steering system is not designed to replace the vehicle’s operator.
NOTE: After the installation of the UniPilot Pro system, verify that all the screws, bolts, nuts, and cable connections are tight. Verify that all
the cables have been secured to prevent them from being damaged.
WARNING: To understand the potential hazards associated with
the operation of a ESD equipped vehicle, read the provided
documentation prior to installing or operating the UniPilot Pro
system.
WARNING: To prevent accidental death or injury from being run over
by the vehicle or automated motion of the steering system,
never leave the vehicle’s operator seat with the UniPilot Pro
system engaged.
WARNING: Movement of the Steering Control Module (SCM Pro)
relative to the vehicle may cause erratic steering and sudden
loss of vehicle control while in AutoSteer mode. Always keep
the Steering Control Module (SCM Pro) firmly secured to the
vehicle. Do not operate your UniPilot Pro system with a loose
SCM Pro.
WARNING: To prevent accidental death or injury from being run over
by the vehicle verify that area around the vehicle is clear of
people and obstacles before startup, calibration, tuning, or
use of the UniPilot Pro system.
WARNING: To prevent the accidental engagement of the UniPilot Pro
system and loss of vehicle control while driving on roads,
turn the ESD power switch to the OFF position or remove the
ESD from the steering column. Never drive on roads or in
public areas with the UniPilot Pro system powered up.
WARNING: The UniPilot Pro system is solely intended for agricultural
use. The systems should only be used with agricultural
vehicles and should not be used with any other type of
vehicle or for any other purposes. Unapproved applications
may result in loss of vehicle control resulting in injury or
death.
