16
HYDROPONIC
C
H
I
L
L
E
R
L
I
N
E
EN
1.5.3 Information on the display
On:
unit in cooling mode (Ref. A9 Fig. 14).
On:
unit in heating mode (Rif. B1 Fig. 14).
Flashing light:
unit ready for cooling (Rif. A9 Fig. 14).
Flashing light:
unit ready for heating (Rif. B1 Fig. 14).
On: alarm condition (Rif. A1 Fig. 14).
1.5.4 Thermostat settings
Refer to fi gure 14 for buttons detection.
1) To change the temperature of the water:
a. Push the button SET for 3 seconds (Rif. A8), display shows the current value
setting and the unit of measure icon (C or F ref C3) starts to blinking.
b. Modify the parameters using the arrows
and
(Rif. C2 and A7)
c. Push the button SET (Rif. A8) to confi rm the values.
2) To adjust the parameter heater (o1)
d. Access to the programming menu by pressing the SET+
button for 3 sec-
onds (Ref. A7 and A8). The icon of the unit of measure selected starts blinking
(C or F Ref. C3) and o1 appears.
e. Press the SET button (ref A8), the current set value is displayed.
f. Change the value using the arrows
and
(Rif. C2 and A7).
g. Press the SET button (Ref. A8) to confi rm the setting and move to the next
parameter.
h. Press SET +
(Ref. A8 and C2) to exit programming mode.
NOTE: If you do not press any buttons for 30 seconds, all settings are
saved and the device is ready for operation.
