TECO TWW22CFAGJBB, User Manual

Page: 8 / 21

8
Installation
Teco Australia Pty Ltd does not warrant the equipment supplied by Teco Australia Pty Ltd, will as installed, comply
with the Building Code of Australia or any other similar standard or code. The customer/contractor is solely
responsible for ensuring that the equipment installed complies with any relevant code or standard.
IMPORTANT NOTICE
Due to various wall and window types and constructions, Teco Australia Pty Ltd recommends the window/wall
type room air conditioner must be installed with compliance to the Building Code of Australia, Local Government
or body corporate requirements. Please consult your local builder or air conditioning contractor.
All hardware required to install the air conditioner is fi eld supplied.
To get the maximum cooling effi ciency, the air conditioner is designed to splash the condensation water on the
condenser coil.
The cooling & heating model has a thermostatically controlled drain mechanicism.
The drain will open <14
o
C (approx.) to allow water to fl ow from the base of the unit and will
close >15 o C (approx.).
WARNING:
Do not push any object into the condensate drain hole as it may damage the condensation water thermostat
mounted above.
For cooling only models, If the splashing sound annoys you, you can provide an outside drain by using the
following procedure, whichmay however cause a small loss of performance.
If a drain is required, please follow the steps below.
1. Slide out the chassis from the cabinet.
2. Remove the rubber plug from the body base plate.
3. Install the drain pan to the corner of the cabinet with 2 screws.
4. Connect the drain hose (fi eld supplied) to the outlet on the drain pan bottom.
5. Slide the chassis into its original place in the cabinet.
Drainage