TECO TECOMAT FOXTROT IB-1301, Basic Documentation

Page: 14 / 16

Basic documentation for IB-1301 module
6. OPERATION
6.1 MODULE CONFIGURATION
The module is operated, set and diagnosed from the MOSAIC development environment.
6.2 PUTTING IN OPERATION
After connection and switching power supply on, the module is ready for its activity. On the
module panel there is set a module address within the system. Other parameters are set from
the Mosaic development environment. The detailed set-up procedure is described in document-
ation TXV 004 10. Other activities are carried out in the MOSAIC development environment.
7. DIAGNOSTICS
The basic diagnostic system of the module is a part of the standard module software. The
diagnostic system becomes active after module power supply is on, and works independently
from the user. The error states being diagnosed are described in documentation TXV 004 10.
8. MAINTENANCE
When following general installation instructions are kept, the module does not require any
other maintenance. Should dismantling of some part of the module be necessary, supply
voltage must always be OFF.
Since the module contains semiconductor components, it is necessary to
follow the principles for working with components sensitive to electrostatic
charges when handling the cover taken off. It is strictly prohibited to touch
printed circuits directly without protective measures!!!
9. GUARANTEE
The guarantee and complaint conditions are governed by the Business conditions of Teco a.s.
Attention:
Before switching the system on, you must fulfil all the conditions contained in this documenta-
tion. The system must not be put in operation, if it is not verified and confirmed that the equip-
ment in which the Foxtrot system is part of it, meets the requirements of the directive
89/392/CEE, if the directive applies to such equipment.
We reserve the right to make modifications and/or changes of the documentation without pri-
or notice.
TXV 113 01 14