TECO 58A, Instruction Manual

Page: 6 / 44

6
ENGLISH • Instructions manual
TECO 58A
®
Automotive Equipment
WARNING!
The machine must not be operated in explosive environments.
6.2 UNPACKING
Once the packing material has been removed, check the machine visually for any signs of damage.
Keep the packing materials out of the reach of children as they can be a source of danger.
N.B.: Keep the packing for possible future transport.
6.3 WORKPLACE REQUIREMENTS
Maximum machine space requirements are 2820 X 2300 mm with a minimum
distance from walls as shown in the
diagram B/4
.
CAUTION! These measurements are also the tyre chang
-
ers working range.
Persons other than specially trained and authorized
operators are expressly forbidden to enter this area
.
Position the tyre changer lifting it with the specific bracket ( 1, Fig. A
) with the
tool carrier arm (
2, Fig. A ) lowered all the way, the spindle ( 3, Fig. A
) closed
and the tool carrier slide (
13, Fig. A
) at its stop close to the arm.
FIXING THE MACHINE
The machine should be fixed to the floor when the
wheels handled weigh more than 1000 kg.
To anchor the machine to the floor use 2 Ø 16 metal
expanding bolts.
Drill holes in the floor at the fixing points in the machine’s
feet as indicated by the arrows in
Figure B/5
.
Insert the expansion bolts in the drilled holes and tighten
the screws all the way.
6.4 ELECTRIC HOOK UP
Before making any electric hook up, check to be certain that the mains voltage corresponds to that stamped on the volt
-
age tag (attached to the cord near the tyre changer’s plug).
It is absolutely essential that :
- the system is equipped with a good grounding circuit.
- The machine is connected to a power supply line circuit breaker set for 30 mA.
B/4
600 mm
2500 mm
1500 mm
2500 mm
B/5