_ Electronic Ovens _ rev. 0 ________________________________________________________________ KF 981 EV _
_________________________________________________________________________________________ page 25 _
5.2
5.2
5.2
5.2 Changing the lighting lamp in the cooking chamber
Changing the lighting lamp in the cooking chamber
Changing the lighting lamp in the cooking chamber
Changing the lighting lamp in the cooking chamber
The lamp is housed between the two door glasses; to replace it remove the internal glass as
described in the paragraph: “Cleaning the door” (paragraph 4.7).
After removing the internal glass, replace the lamp with another with the same
specifications: 12V 35W 300°C (this is a halogen lamp and should not be touched with your
bare hands).
5.3
5.3
5.3
5.3 Changing the door seal
Changing the door seal
Changing the door seal
Changing the door seal
The door seal has a rigid profile with fixing tabs. The profile must be fitted into the guide on
the face of the cooking chamber.
To change the seal, remove the old one from the guide by pulling hard at the four corners.
Clean any dirt from the guide and introduce the new seal (to make this operation easier, we
advise dampening the seal profile with soapy water).
5.4
5.4
5.4
5.4 Changing the fuse
Changing the fuse
Changing the fuse
Changing the fuse
If the appliance is powered but no displays or leds are alight on the control panel, it could
mean that one of the fuses has burnt in the electronic (power) card. To reach the card, remove
the left side of the appliance (unscrewing the 3 screws). The two fuse holders are clearly visible
on the card. To change the fuse, press gently on the cap of the fuse hold and, keeping it
pressed, turn it slightly in an anti-clockwise direction to remove it. Replace the fuse with another
with the same specifications and then close the fuse holder cap by turning it in the opposite
direction.
5.5
5.5
5.5
5.5 Resetting the thermal breaker safety device
Resetting the thermal breaker safety device
Resetting the thermal breaker safety device
Resetting the thermal breaker safety device
This device is reached by removing the left side of the appliance and can be reset by pressing
the key right down (which is marked by a special adhesive label), which is inside the electric
components compartment.
5.6
5.6
5.6
5.6 Possible faults
Possible faults
Possible faults
Possible faults
Type of fault
Type of fault
Type of fault
Type of fault
Cause
Cause
Cause
Cause
Corrective action
Corrective action
Corrective action
Corrective action
-
Incorrect electric connections to the mains
-
Check the mains connection
-
No mains voltage
-
Restore mains voltage
-
Thermal break safety device tripped
-
Reset the thermal break safety
device
Control panel
completely off (the
oven does not work)
-
Electronic card protection fuse (power)
burnt
-
Change the fuse
-
Door open or ajar
-
Close the door
Cooking cycle set
and START push
button pressed: the
oven does not work
-
Damaged magnetic sensor
-
Contact a qualified technician to
repair the sensor
-
Incorrect connection to water mains
-
Check the connection to water
mains
-
Cut-off cock closed
-
Check the cut-off cock
-
Blocked water inlet filter
-
Clean the filter
Boiler ON: no steam
is produced in the
cooking chamber
-
Damaged water inlet solenoid
-
Contact a qualified technician to
repair the solenoid
-
Seal not fitted correctly
-
Check the seal fitting
-
Damaged seal
-
Contact a qualified technician to
repair the seal
Door closed: steam
comes out of the
seal
-
Handle prong loosened
-
Contact a qualified technician to
repair the prong
