TECNOEKA KCV 96 Use And Instruction Manual Download Page 10

Page: 10 / 20

_ TECNOEKA Srl _________________________________________________________ use and instruction manual _

_ page 10 ________________________________________________________________________________________

5. Electric connection

Before performing the electric connection

Before performing the electric connection, make sure that:

the relief valve and the system can stand the appliance load (see data on the rating
plate);

THE SUPPLY SYSTEM IS EQUIPPED WITH AN APPROPRIATE GROUND CONNECTION IN
ACCORDANCE WITH THE REGULATIONS IN FORCE;

the omnipolar system used for the connection can be easily reached with the appliance
installed.

In the grid-connected mode, between the appliance and the grid an omnipolar switch must
be inserted, having a 3 mm minimum opening between contacts, suitable to the load used
and in accordance with the regulations in force. The yellow/green earth cable must not be

The yellow/green earth cable must not be

interrupted by the switch.

Connection of power cable

Mod. KCV 96

P - The terminal board is on the rear panel of the appliance. Open the terminal

board cover by obtaining leverage with a screwdriver on the two side fins. Loosen the cable
gripper screw and allow the cable to pass through it. Arrange the conductors so that the earth
conductor is the last to detach from its terminal if the cable goes into a state of faulty traction.

Connect the phase conductor to the terminal marked with the letter "L", the neutral

conductor to the terminal marked with the letter "N" and the earth conductor to the terminal
marked with the symbol

. Tighten the ring-nut of the cable gripper and close the terminal

board  cover.  The  appliance  must  be  connected  to  an  equipotential  system  whose  efficiency
must  first  be  checked  according  to  current  legal  regulations.  This  connection  must  be  made
between different appliances by using the appropriate terminal marked with the symbol  . The
equipotential conductor must have a minimum diameter of 10 mm

The equipotential terminal

is at the rear of the appliance. When the appliance is operating, the supplied voltage must not
deviate from the nominal voltage value of ±10%.

Mod

d. KCV 96

. KCV 96

. KCV 96 - For access to the terminal board, remove the rear panel of the appliance.

Loosen the cable gripper and allow the cable to pass through. Locate the conductors so that the
earth  cable  is  the  last  to  detach  from  its  terminal  in  the  event  of  reverse  pulling.  Connect  the
phase  conductors  on  the  terminals  marked  “L1”  and  “L2”,  the  neutral  conductor  to  the
terminal  marked  “N”,  and  the  earth  conductor  to  the  terminal  marked  with  symbol

according to the following lay-out:

380

380 ---- 400V~ 2N

400V~ 2N

(this  electrical  connection  lay-out  is  also  available  near  the  power  supply  terminal  board).
Tighten  the  cable  gripper  and  re-fit  the  rear  panel  of  the  appliance.  The  appliance  must  be
connected  to  an  unipotential  system  whose  efficiency  must  be  suitably  verified  according  to
current legal regulations.

This connection must be made between different appliances using the terminal marked with

the symbol

. The unipotential conductor must have minimum diameter of 10 mm

. The

unipotential terminal is located low down at the rear of the appliance.

Make sure that after inserting the power supply cord into the terminal block it does not come

into contact with any of the cooking range's hot parts.