Tecma Nano Owner’s & Installation Manual
6
www.thetfordmarine.com
Orientation
A.
Filter or Strainer (Raw Water Install)
B.
Water Tank (Fresh Water Install)
C. Non-Thetford Water Pump (Raw Water
Install)
Fresh Water Pressure Pump (Fresh Water
Install)
D. 3/4” Water Supply (Raw Water Install)
E.
1/2” Water Supply (Fresh Water Install)
F.
Vented Loop
A
A1
B
B1
C
C1
D
A. Toilet Discharge Hose
B.
Relay Module
C. Water Pump Wiring (Fig. B)
D.
Discharge Line (above or below floor)
E.
Holding Tank
F.
Boat/Craft 12V DC Power Source
G.
Mimimum 3/4” floor
E
F
G
H
I
J
K
A.
Fresh Water Hook-up
B.
Wiring Harness
C. Bezel (Fig. F)
D. Wall Switch
Thetford Water Pump (Raw Water Install)
Raw Water Pump Hook-Up
E.
Lower Discharge Check Valve (Vertical)
K3
K1
K4
K5
K6
K8
#4
Fig. E
IF NEEDED-8” above
waterline ALL TIMES!
AR
T00203
Fresh Water Install
A1
Floor-minimum 3/4”
K6
OR
B
D
C
K
E
H
G
A
I
H
J
F
C1
B1
K3
K5
K4
K8
K1
4
Mounting Location
■
Ideally, the Nano Eco toilet should be installed in a location that is higher than the holding tank. A (maximum) 6' rise between the
toilet and holding tank will not impact performance.
■
Using toilet and supplied template, verify that the installation site has:
• sufficient clearance between toilet and nearby wall so that water supply hose and discharge hose are not kinked
•
room for maintenance accessibility
■ The floor supporting the toilet is level and strong enough to support toilet and weight of any potential user.
■ The floor structure is strong enough to securely anchor toilet using supplied screws; 3/4” minimum.
■ The flooring is water-resistant so structure and anchoring integrity are maintained.
Before starting the installation, consider and plan for the following:
Summary of Contents for Nano ECO
Page 1: ......
