TECHWOOD LED19AK13DVX, Operating Instructions Manual

Page: 7 / 57

English - 5 -
Input Selection
Once you have connected external systems to your
TV, you can switch to different input sources. Press
SOURCE button on your remote control consecutively
to select the different sources.
Changing Channels and Volume
You can change the channel and adjust the volume by
using the V ^ / v and CH ^ / v buttons on the remote.
Installing the Batteries to the Remote
1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match
the + and - ends of the batteries in the battery
compartment (observe the correct polarity.
3. Replace the cover.
IMPORTANT : The TV set is designed to operate on 12
V DC. For this, an adaptor is used which gives 12 V
voltage. Connect this adaptor to a system that supplies
110-240V AC, 50/60Hz. After unpacking, allow the TV
set to reach the ambient room temperature before you
connect the set to the mains.
VGA
SPDIF
Coax.OUT
12V
DC IN
Aerial or Cable
To POWER
INPUT DC 12 V
terminal
AC adapter
VGA
SPDIF
Coax.OUT
12V
DC IN
DVD - Control buttons
A- Disc loader
B-
Play / Pause ( / ) button
Plays / pauses the disc. When DVD menu (root
menu) is active, this button functions as “button
select” (selects the highlighted item in menu) if
this is not prohibited by the disc).
C- Stop / Eject ( / ) button
Stops the disc playing / Ejects or Loads the
disc.
NOTE : You cannot eject the disc via the remote
control. To eject while playing a file; you should press the
STOP button “
/ ” (on the TV) three times.